Power supply assembly
Attention: Do not open your computer or attempt any repair before reading and understanding the
Appendix A "Important safety information" on page 67.
Although there are no moving parts in your computer after the power cord has been disconnected, the
following warnings are required for your safety and proper Underwriters Laboratories (UL) certification.
CAUTION:
Keep fingers and other parts of your body away from hazardous, moving parts. If you suffer an injury,
seek medical care immediately.
DANGER
Disconnect all power cords from electrical outlets before removing the computer cover or any part
that has the above label attached.
To remove and install the power supply assembly, do the following:
1. Prepare your computer. See "Preparing your computer" on page 24.
2. To remove the power supply assembly, do the following:
a. Disconnect the power supply assembly cables from the system board and all drives.
b. Release the power supply assembly cables from the cable clips and ties.
.
Chapter 6
Hardware removal and installation
43