Mohu Sail Instructions

INSTRUCTIONS
FIRSTSTAGE AMPLIFIED INDOOR / OUTDOOR HDTV ANTENNA
30 ft. Coaxial Cable
Sail Antenna
Power Injector USB Power Adapter*
*Actual USB power adapter may di er in appearance.
FOLLOW ALL SAFETY PROCEDURES, WARNINGS, AND
INSTRUCTIONS WHEN INSTALLING YOUR ANTENNA.
SAFETY PROCEDURES
- Make sure there is another person present (on the ground) while
installing the antenna.
- DO NOT attempt to mount the antenna on a windy, rainy, or
snowy day.
Select mounting location;
ideally wood framework
indoors (in attic) or outdoors
(roof/siding).
1
Position the mounting bracket
(flat surface to wood) to create
an " " shape when viewed from
straight on.
Secure the mounting bracket by
using the four large outdoor
screws.
Place the U-bolt under the
bottom toothed plate, and
secure the plate to the antenna
with the 4 included screws and
washers.
Sandwich the mast between the
bottom and top toothed
brackets and secure with the
2
included wingnuts.
Insert the short end of the mast
into the mounting bracket.
Use the two carriage bolts and
washers to secure the mast to
the mounting bracket.
If you have any di culties with the installation of your antenna, please contact Mohu®.
Si tiene alguna dificultad instalando su antena, por favor contacte a Mohu®.
support@gomohu.com
BOX INCLUDES
Antenna Mounting Hardware
x4 - Screws
x4 - Washers
x4 - Outdoor Screws
x2 - Wing Nuts
x1 - U-Bolt
A
B
II 1.877.825.5572 II www.gomohu.com
x2 - Carriage Bolts
x2 - Flange Nuts
IMPORTANT
MOUNT THE ANTENNA AT LEAST 20 FT. FROM ALL
POWER LINES OR UTILITY POLES.
POWER LINE WARNING
If you intend to mount the antenna on a rooftop, make sure to
mount it at least 20 ft. away from any power lines or utility poles.
3
4
POWER OPTIONS:
a. TV's USB Port
b. Wall Outlet
Two and Four-Hole
Antenna Mounting Brackets
and Teeth
Mounting Bracket
Mast
Connect one end of the 30 ft. Coaxial
Cable to the connector on the antenna
(see illustration below) and connect the
other end of the coaxial cable to the
power injector.
Note: Excessive cable length may cause reception
loss.
Connect the coaxial cable from the power
injector to the ANT/IN connector on the
back of the TV.
The power injector must be powered in
order to function. Plug the power
injector's USB cable into an open USB
port on the back of the TV.
If the TV does not have a USB port, use
the included USB power adapter with any
standard 120V wall outlet.
Note: If using an RF
splitter, follow the RF
splitter installation
instructions on the
back of this page.
30 ft.
Coaxial Cable
Power Injector
USB Cable (attached)
Back of TV
OR
Continued
Coaxial
Cable
(attached)
ANT/IN