Troubleshooting; Contact Information - Laser PJT-DVD01-BLK Manual

TROUBLESHOOTING

Before resorting the maintenance service, please kindly check by yourself with the following chart.
No Image is Projected or
a "No Signal" message is
displayed
The Lamp (Bulb) switches
off after a period of time
The Image is wider at
the top/bottom of the
screen
Spots on the screen
The image brightness
has faded

CONTACT INFORMATION

For more information on this product and technical support please visit
https://www.laserco.com.au/
Power light is on. If it is not on, check the
1.
projector is plugged into the mains, that the
socket is switched on, and then press the power
button on the projector.
Check the lens cover has been removed.
2.
3.Check the cables are securely attached and
installed as per the User Manual.
The image source may not be set correctly.
4.
Press the Source button on the Control Panel or
the Remote, to select the correct setting.
Check in the Menu section under Video input
5.
signal to make sure that has been set correctly.
Is the warning light indicator red? If so, the
projector is overheating which turns the light
off automatically.
1.Leave the projector to cool for a few moments.
2.Once cooled, check nothing is blocking the
ventilation vents.
Check the air filter is clean and clean if
3.
necessary.
Turn on the projector.
4.
If the issue persists, please contact your
support provider for further assistance.
This is called keystone and is due to the projection
angle not being perpendicular to the screen. To
correct use the projectors inbuilt keystone
function to adjust the image.
Using a vacuum cleaner to clean the lens. If
cleaning doesn't resolve things, please contact
your support provider for further assistance.
Check the room ambient brightness is the same.
You may need to change the lamp (bulb)