ADC PowerWorx Power Distribution Products User Manual page 10

ADCP-80-526 • Issue 6 • December 2006
• Rear protective input terminal covers and output terminal covers—Used to prevent
accidental contact with the power input and output terminals. The number of covers
provided depends on the fuse configuration.
• Designation card and card holder—Used to record information about the protected
equipment. The card holder has a pressure-sensitive adhesive backing to permit
attachment to the panel, the rack, or a location close to the panel. The designation card
inserts into the card holder. It is also available as an accessory item.
DESIGNATION CARD,
PROTECTIVE COVER,
AND CARD HOLDER
Page 4
© 2006, ADC Telecommunications, Inc.
REAR COVER FOR OUTPUT POWER TERMINAL BLOCKS,
ALARM TERMINALS, AND CHASSIS GROUND TERMINALS
REAR COVERS FOR INPUT
POWER TERMINAL BLOCKS
MOUNTING BRACKETS
AND SCREWS FOR 19-INCH OR
23-INCH RACK INSTALLATION
Figure 2. Packaged Hardware Components
#10 RING TERMINALS FOR
12-10 AWG WIRE (GROUNDING)
5/16-INCH (7.936 MM) 8-32
FLAT-HEAD SCREWS
19-INCH
RACK MOUNTING
BRACKETS
3/8-INCH (9.525 MM) 12-24
SCREWS AND #12 WASHERS
23-INCH
RACK MOUNTING
BRACKETS
18876-A