Introduction; Intended Use; Features - Hyundai HYPT5200X Instruction Manual

POLE SAW / HEDGE TRIMMER

Introduction

The operating instructions are a part of this product. They contain
important information about safety, usage and disposal. Before using the
product, please familiarise yourself with all operating and safety
instructions. Use the product only as described and for the range of
applications specified. Please also pass these operating instructions on to
any future owner.

Intended use

Lon -handled hed e trimmer
g g
This appliance is intended for the cutting and trimming of hedges, bushes
and flowering shrubs in the home environment. This is a hand-held
appliance with an integrated engine unit with linear reciprocating cutting
blades.
& WARNING!
► Hedge trimmers are not suitable for use by children.
Pole Saw
This appliance is intended for trimming branches in trees.
Any other use that is not expressly permitted in these operating instructions
may damage the appliance and represents a serious risk for the user.
Please make sure that you pay attention to the restrictions in the safety
instructions. Comply with all national regulations which may restrict the
use of the machine. Any other uses of or modification to the appliance is
deemed to be improper and carries the risk of serious personal injury.
Not intended for commercial use.
PROHIBITED APPLICATIONS!
Due to the physical risk posed to the user, the appliance may not be used
to perform the following activities: cleaning footpaths and as a shredder
for shredding tree and hedge sections. Furthermore, the appliance may not
be used to level ground elevations such as molehills. For safety reasons,
the appliance may not be used as a drive unit for any other devices. The
user, not the manufacturer, is liable for any resulting damage or injuries of
any kind.

Features

Engine Unit
Safety lock-out
On/Off switch
Carrying lug
4 x mounted bolts (with snap ring, washer and nut)
Round handle
Rubber ring
Pin
Barrier bar
Screw grip
Boom
Throttle control
Spark plug connector
Choke lever
Starter pull cord
Fuel tank
Filler cap
Fuel pump (primer)
Air filter housing cover
■
2
Hedge Trimmer
17. Handle
18. Lock/release
19. Gear housing
20. Cutter bar
21. Base plate (hedge trimmer)
22. Control lever
23. Front boom (hedge trimmer)
24. Locking pin
25. Drive shaft
Pole Saw
26. Front boom (pole saw)
27. Safety ring
28. Oil filler cap
29. Oil tank
30. Blade
31. Saw chain
32. Bench grinder support
33. Stop
34. Locking pin
35. Drive shaft
36. Nut
37. Thread
38. Sprocket cover
39. Blade guide
40. Blade hole
41. Guide rail
42. Oil dispenser
43. Chain sprocket
44. Oil adjusting screw
45. Chain tensioner pin
46. Chain tensioner screw
Accessories
47. Harness
48. Protective cover for blade
49. Chain guard
50. Oil / petrol mixing container
51. Hex key M4
52. Hex key M5
53. Open-ended spanner SW 8/10
54. Spark plug wrench/flat-blade screwdriver
55. Tool Bag
Extension Attachment
56. Locking pin
57. Drive shaft
58. Boom
59. Screw grip