Advertisement
Quick Links
Advertisement
Related Manuals for ANTUMBRA ROT8
Summary of Contents for ANTUMBRA ROT8
- Page 1 ANTUMBRA ROT8 BUILDING INSTRUCTIONS PCB V1.4...
- Page 2 01. BUILD NOTES Before you start building look through the build manual so that you’ll be familiar with the building process and you won’t run into any surprises!
- Page 3 02. BUILD 00. Orient the PCB as seen on the left Solder the ATMEGA328P-AU in place (The dot should be on the bottom right) Solder the CD4021 in place (Oriented to the bottom)
- Page 4 02. BUILD Solder the two CD4066s (Oriented to the top) 04. Solder the two opamps TL072 MCP6002 (Oriented to the bottom, cut edge on the right)
- Page 5 02. BUILD Solder the 16MHZ crystal Solder the LM4040 IC Solder the 7805 voltage regulator 7805...
- Page 6 02. BUILD Solder the three SN74HC595s (Left two facing down, right one facing up) Solder the two MMBT3904s Solder the two 1N5819 diodes (Check their orientations, lines should match up with silkscreen drawing) 7805...
- Page 7 02. BUILD Solder the eight 1N4148 diodes (Check their orientations, lines should match up with silkscreen drawing) Solder the two 100ohm resistors Solder the three 1k resistors 7805...
- Page 8 02. BUILD Solder the four 10k resistors Solder the ten 100k resistors Solder the 31x470 resistors 7805...
- Page 9 02. BUILD Solder the two 10nF capacitors Solder the nine 100nF capacitors Solder the single 470nF capacitor 7805...
- Page 10 02. BUILD Solder the two 22pF capacitors Solder the four 10uF capacitors (Make sure to match up it’s orientation with the silk- screen drawing) 22. Flip the board! 7805...
- Page 11 02. BUILD Solder the pin headers Solder the single 100ohm resistor Solder the six SMD LEDs (They have to be soldered upside down, so that the LED part is in the hole. Marker should face left)
- Page 12 02. BUILD 26. Flip the board back DO NOT SOLDER YET! Place the 6 jacks Place the 10 pots 7805...
- Page 13 02. BUILD Place the 11 buttons Place the 6 single color LEDs (Long leg goes in the hole with the + mark) Place the 8 dual color LEDs (Flat side of LED faces inwards) 7805...
- Page 14 02. BUILD 32. Put on the caps of the buttons. 33. Place the front panel on top, tighten the jack and pot nuts, make sure that everything is nice and vertical. Adjust the LEDs in the holes as you like. 34.
-
Page 15: Uploading Sof T Ware
03. UPLOADING SOF T WARE 1. Download the firmware from the Antumbra website. 2. Connect your AVR ISP device to the 6 pin ISP header on the module. Pin 1 is marked with a dot. 3. Use an AVR programmer, like AVR ISP MKII with for... - Page 16 ROT8 is designed by David Szebenyi under Antumbra. www.antumbra.eu Manual by David Szebenyi (www.aman.hu) 2017 • All rights reserved!
Need help?
Do you have a question about the ROT8 and is the answer not in the manual?
Questions and answers