Panasonic ET-ELW02 Lens Replacement And Installation Procedure page 6

z
zLens lock lever fixing bracket for each
lens
Refer to the following table and use the light-
shielding plate that corresponds to the lens.
Lens lock lever fixing
bracket
(6103579818)
Type SC-A
Type SC-B
10) Insert the upper light-shielding plate
into the guide of the lower light-
shielding plate.
Lower plate
Attention
z When inserting the upper light-shielding plate, the
lower light-shielding plate should be lifted upward.
z Make sure that the attaching direction of the light-
shielding plate is correct and set them properly.
z If you cannot set the upper light-shielding plate
easily, move the projection screen from the center
to the upper side with the lens shift function in
advance.
11) Slide the lens attachment cover and
fix it with two screws A.
Lens attachment cover
5-
ENGLISH
Lens No.
ET-ELW02, ET-ELW03,
ET-ELW04, ET-ELW06,
ET-ELS02, ET-ELS03,
ET-ELT02, ET-ELT03,
ET-ELM01
None
Upper plate
12) Check that the lens and light-
shielding plate are set properly.
z
z Turn on the projector. Operate the lens shift,
zoom, and focus fully to check that the light-
shielding plates are moved with the lens. If
the light-shielding plate interferes with those
operations, set the light-shielding plate again.
Attention
z Do not operate the projector with the light-shielding
plate removed. Doing so may result in malfunction
of the projector.
■ Notes on attaching ET-ELW03 z
When attaching ET-ELW03, use two types of light-
shielding plates.
Follow the procedure on "Attaching the lens"
( page ENGLISH-3) to set the light-shielding

plate-3, and follow the procedure below to set the
light-shielding plate-1.
Attention
z The side with <THIS SIDE BACK> must face
backward.
1) Before setting the light-shielding
plate-1, turn on the projector and move
the projected image to the most upper
left with the lens shift function.
2) Turn off the projector.
3) Insert the light-shielding plate-1 in the
direction shown in the figure and set it
to encircle the lens.
z
z Set the light-shielding plates with the convex
side of the light-shielding plate-1 down.
Light-shielding plate-1
(In front of the light-shielding plate-3)
Light-shielding plate-3