Panasonic ET-ELW02 Lens Replacement And Installation Procedure page 4

Attaching the lens
Attention
z The attachment procedure and parts vary depending on optional lenses. Check the Product No. of the optional
lens and attach or replace the lens properly.
z When using ET-ELW02, ET-ELS02, ET-ELS03, ET-ELT02, or ET-ELM01, tie up the cables using the cable
ties supplied with the projector before attaching the lens. If you attach the lens without tying up the cables, the
cables may contact the internal parts, causing malfunctions.
1) Install the lens attachment to the lens.
(i) Remove the lens covers on the front and rear of
the lens, install the lens attachment, and secure
with four screws supplied with the lens.
Focus lock screw
Locate the motor on the right side.
(ii) Connect the lens motor lead to the socket on
the top right of the lens attachment (the motor
driven lens only).
Lens attachment
Lens motor lead
2) Set the projector to the standby mode,
press the < > side of the main power
switch to turn off the power, and
unplug the power cord from the outlet.
3-
ENGLISH
Lens attachment
Socket
Connector
3) Remove two screws A and slide the
lens attachment cover forward to take
off.
Lens attachment cover
4) Remove the cover plate.
Cover plate
5) Select the light-shielding plate to be
attached.
z
zLight-shielding plate for each lens
Refer to the following table and use the light-
shielding plate that corresponds to the lens.
Accessory (product name)
Light-shielding plate-1
(6103379906)
Light-shielding plate-2
(6103370064)
is inscribed
Light-shielding plate-3
(6103370224)
is inscribed
*1: Use the light-shielding plate-1 and light-shielding plate-3
together.
Lens No.
ET-ELW03 *1
ET-ELW04,
ET-ELW06,
ET-ELS02,
ET-ELS03,
ET-ELT03
ET-ELW02,
ET-ELW03 ,
*1
ET-ELT02,
ET-ELM01