Panasonic ET-ELW02 Lens Replacement And Installation Procedure page 5

Attention
z The light-shielding plate-2 and light-shielding
plate-3 should be separated to the upper and lower
plates.
z Make sure that the shape of the light-shielding plate
matches the lens.
z Make sure that the attaching direction of the light-
shielding plate is correct and set them properly.
6) Insert the lower light-shielding plate.
7) Attach the lens into the projector.
(i) Hold the lens lock lever and slide it upward to
release the lock, and then insert the lens with
the lens attachment into the projector.
(ii) Hold the lens lock lever and slide it downward
until the lever clicks to secure the lens.
• When attaching the motor driven lens, be sure
to mount the lens motor on the right side.
• After attaching the lens, make sure the lens is
not loose and properly attached.
8) Adjust the focus of the projection lens
Upper plate
9) Secure the lens lock lever with the lens
Lower plate
(ET-ELW03 only).
z
z For details, refer to "Adjusting the focus"
( page ENGLISH-6).

z
z If the focus adjustment is not necessary, go to
step 9).
lock lever fixing bracket.
(i) Remove the screw fixing the lens and insert it to
the lens lock lever fixing bracket.
Lens lock lever fixing bracket (Type SC-A)
(6103579818)
Lens lock lever
(ii) Place the lens lock lever fixing bracket in the
location of the removed screw.
• Make sure that the lens lock lever fixing
bracket is mounted to hold the lens lock lever
in the lock position. Make sure that the lens
lock lever fixing bracket is placed properly
shown in the figure.
Lens lock lever
Attention
z To ensure that the lens is securely fixed to the
projector when mounting, be sure to attach the
provided lens lock lever fixing bracket. There are
two types of the lens lock lever fixing bracket.
Check the Product No. of the lens and use a lens
lock lever fixing bracket that matches to the lens.
Screw
Lens lock lever fixing
bracket (Type SC-A)
(6103579818)
-4
ENGLISH