Adjusting Your Monitor Image; Using The Direct Access Controls; Using The On-Screen Display (Osd) Controls - Lenovo D19-10 User Manual

Adjusting your monitor image

Using the direct access controls

Using the On-Screen Display (OSD) controls

2-4 D19-10 Flat Panel Monitor User's Guide
This section describes the user control features used to adjust your monitor image.
The direct access controls can be used when the On Screen Display (OSD) is not displayed.
Note: The direct access controls are coloured.
Table 2-1. Direct access controls
Icon
The settings adjustable with the user controls are viewed through the On-Screen Display (OSD),
as shown below.
To use the controls:
1. Press to open the main OSD menu.
2. Use or to move among the icons. Select an icon and press
function. If there is a sub-menu, you can move between options using
press to select that function. Use
save.
3. Press to move backwards through the sub-menus and exit from the OSD.
4. When un-OSD, press and hold
accidental adjustments to the OSD. When un-OSD ,press and hold
unlock the OSD and allow adjustments to the OSD.
5. Enables DDC/CI by default. Use OSD Exit Key, press and hold the
seconds to disable/enable DDC/CI function. The words " DDC/CI
Disable/DDC/CI/Enable" shows on the screen.
Control Description
Input change Switches the video input source.
Image Setup Activates automatic image adjustment.
Brightness Direct access to Brightness adjustment.
Press and hold for 3 seconds to
Low Blue Light
enable/disable Low Blue Light.
Main menu Open OSD main menu
or to make adjustments. Press
for 10 seconds to lock the OSD. This will prevent
to access that
or , then
to
for 10 seconds to
buttons for 10