ClimaRad 2.0 Maintenance Instructions

Maintenance Instructions Clima ad 2.0
Maintenance frequency for filters
When should you replace the filters?
• With normal use, every 2 years or earlier if the message 'Filter
the display (for example in homes and offices).
• In the case of intensive use, after 1 year or earlier if the message 'Filter
appears on the display (e.g. for care homes and schools).
Go to www.climaRad.nl/filtervervanging
Replacing air supply filters
1. Switch off the device first by
removing the plug from the
socket.
left
2
4. Push the left-hand and right-
hand slide on top of the ClimaRad
inwards and open both covers by
pulling them towards you.
left
7. Replace the black filter caps on
the left and right.
Important: Reset the filter hour counter only if you have replaced
the filters.
to view the instruction video.
2. There is a locking screw at the
bottom of each of the two (or
four) radiator consoles. Remove
these locking screws.
right
1 1
left
5. Remove the black filter caps on
the left and right.
right
left
8. Close the covers on the left-
hand and right-hand side of the
unit, and slide both latching slides
outwards.
R
F u t u r e c o m f o r t t o d a y
veruild ' appears on
vervuild '
3. Tilt the radiator and, if
required, lock it with an Allen key
or screwdriver.
Slide 3 new filters in
right
6. Slide the three new filters in the
unit from the left-hand side. The
old filters will automatically slide
out on the right-hand side.
right
9. Unlock the radiator and tilt it
back. Push the plug back into the
socket and reset the filter hour
counter (by simultaneously pressing
on the + and - on the display for 6
seconds ). The message 'Filter
vervuild' will disappear. Tighten the
locking screws again.
Ordering filters
Order new filters at
www.climarad.nl/filters
3 old filters will
slide out
Press
and
for 6 seconds