Advertisement
HARDWARE PACK. Remove parts from the package
and identify as listed below.
QTY. PART NO.
DESCRIPTION
4
710-0157
Hex Bolts 5/16-24 x .75" Long
4
712-0123
Hex Nuts 5/16-24 Thread
4
736-0119
Lock Washers 5/16" I.D.
2
712-0292
Speed Nuts 1/4-20 Thread
1
731-0757
Plastic Convoluted Conduit 28"
1
712-3008
Hex Jam Nut 3/8-16 Thread
2
777-2738
"Do Not Step" Label
1
781-0624
Taillight Bracket
1
681-0074
Taillight Bracket w/License
1
625-0009
Light Kit
Taillight (1)
Taillight w/Clear Lens for
Mounting Screws (4)
Nuts (4)
Lock Washers (4)
Wire Harness (1)
Reflectors (2)
Electrical Fasteners (5)
The right and left side of the log splitter is determined
from standing behind the log splitter when it is in the
towing position. See figure 7.
1. Remove the rear fender mounting hardware and
discard.
If Needed
Drill 5/16"
Hole
Remove
FIGURE 1.
ASSEMBLY INSTRUCTIONS
Long
Plate Bracket
License Plate (1)
2. Mount the two taillight brackets to the log splitter
fender braces using the (4) 5/16-24 x .75" long
hex bolts, (4) 5/16" lock washers and (4) 5/16-18
hex nuts. Stick the "Do Not Step" labels on top of
the taillight brackets.
The taillight bracket with the extended arm for the
license place mounts on the left fender brace.
Taillight
Bracket
Hex Head Cap Screw
Lock Washer
Hex Nut
FIGURE 2.
NOTE: If your log splitter does not have the front hole
for the taillight brackets in the fender brace, use the
taillight bracket as a template and drill out the hole with
a 5/16" drill bit.
CAUTION: Place a piece of wood between the fender
and tire to prevent the drill bit from piercing the tire.
3. Snap the two 1/4-20 speed nuts on the taillight
bracket which has the license plate arm.
Speed Nut
FIGURE 3.
5
Speed
Nut
Taillight
Bracket
Advertisement
