Structure And Function; Cover Lock - Lenoxx Healthy Choice VS110 Manual

STRUCTURE AND FUNCTION:

VACUUM STRUCTURE
Vacuum Sealing strip
After the upper cover and the base are buckled (locked) together, the upper and lower
Vacuum Sealing strip fit together to form a vacuum chamber.
IMPORTANT! When removing the vacuum bag for installation and cleaning, be careful
not to distort or damage the sealing strip.
Vacuum room
Place opening end of the vacuum bag into the vacuum room, fit the upper and lower
vacuum sealing strip together to form a vacuum chamber, after the vacuum operation is
performed, the air in the bag is drawn out.
Food residue, dust and other fine particles will be pumped out and collected in the drip tray,
please ensure to clean the drip tray regularly.
SEALING STRUCTURE
Heat sealing strip and silicone sealing strip
When sealing, this part can reach high temperatures with the silicone sealing strip to seal
the vacuum bag.
Do not touch it with your hands to avoid getting injured.
External vacuum function
Vacuum pipe
Equipped with two vacuum pipes for external pumping, it is suitable for most vacuum canister
and bags as well as wine bottles on the market.
Vacuum hole and switch
After inserting matching end of the outer suction tube to the vacuum hole, connect it to the
container to be evacuated. Press the outer pumping button on the right side of the hole to start
the vacuum.
After the vacuum is completed, it can be automatically stopped or pressed again to manually
stop the evacuation.

COVER LOCK

Buckle
For locking the cover and the base, hold the vacuum bag in tight.
Close the cover and the base press down the cover to lock it with the base by the buckle.
When not in use close the cover only and keep it unlocked to prevent damage to the
vacuum sealing strip.
Open button
Press the buttons on both sides at the same time to unlock the cover and the base.
CUTTER
Operate: Pull out the roll bag from the storage bag slot to the desired length.
After closing the cover, you can cut the vacuum bag and then seal it.
Steps can also be reversed, and the bag with an open end is completed.
Replace: The cutter body and the blade can be separated. Put the cutter to the side. Open the
knife side by force. The cutter can be divided into two parts along the cutter chute.
After replacing the new blade, it can be regrouped along the chute