NESTLE ReadyRefresh Lumina User Manual page 9

4.0 Dispenser Care
10. Remove the upper cartridge from the packaging.
Holding the handle of the upper water cartridge:
A Feed upper cartridge tube down the small,
round cavity near the front of the unit
B Align the dispensing tube to the front
C Gently lower the reservoir bottle into the
large, round opening
D Align the handle inlet to the steam chamber
11. Once all components are in place, push firmly
on the handle to fully seal, and press foam ring
down into place, securing the opening of the
cold reservoir.
12. Press down and click the gray bracket closed,
then close the lid.
14
(continued)
13. Bring in a new, full 5-gallon bottle of water over
to your dispenser. Remove entire cap by holding
tab firmly, peeling halfway around bottle neck
and pulling upwards.
14. Put on supplied gloves and remove lower
cartridge from packaging. Lower dip tube into
new, full bottle and secure cap onto bottle
opening. Press down on clamping lever to lock.
15. Remove red hygiene cap from upper cartridge
tube, and discard. Ensure side tabs are aligned
with the slots. Push down to lock into place.
16. Attach red air connector to inlet on cap.
The connection should be tight and secure.
17. Slide bottle inside cabinet, ensuring no tubes are
pinched or kinked. Close cabinet door. To prime,
see step 3.5.
LUMINA BOTTOM-LOAD DISPENSER USER GUIDE | 15