Table of Contents
Advertisement
3.0 Setup & Installation
3.3 Water Bottle Installation
1. Remove entire cap by holding tab firmly, peeling
halfway around bottle neck and pulling upwards.
2. Put on supplied gloves and remove lower
cartridge from packaging. Lower dip tube into
new, full bottle and secure cap onto bottle
opening. Press down on clamping lever to lock.
3. Remove red hygiene cap from upper cartridge
tube, and discard. Ensure side tabs are aligned
with the slots of the lower cartridge cap.
Push down to lock into place. The upper
cartridge tube and red air connector will be
found inside the cabinet.
4. Attach red air connector to inlet on cap.
The connection should be tight and secure.
5. Slide bottle inside cabinet, ensuring no tubes are
pinched or kinked. Close cabinet door.
8
(continued)
3.4 Power
1. Before powering on the unit, ensure the hot
water switch is in the OFF position.
HOT TANK
SWITCH
2. Plug the unit into a grounded wall outlet. Do not
use an extension cord.
3.5 Priming System
1. Place cup on cup stand. Lift red safety lever,
and simultaneously press and hold the
hot & cold levers for one second, then release.
Priming has started when you see flashing
dispensing light. After two minutes, the light will
stop flashing and dispenser is ready for use.
3.6 Activating Hot Water
IMPORTANT: The unit must be primed before
activating the hot water.
HOT TANK
SWITCH
1. Turn on the hot water switch located inside
the cabinet.
LUMINA BOTTOM-LOAD DISPENSER USER GUIDE | 9
Hide quick links:
Advertisement
Table of Contents
