PROHIBITED Disclaimer Makinex, and its affiliates, takes no responsibility for any damage, injury or death resulting from the incorrect or unsafe use of this machine. Use of this machine should be undertaken by competent persons only. It is the operators’ responsibility to ensure that the following safety procedures are followed.
PRODUCT INFORMATION Safety Information General Safety Instructions Throughout this document there are several safety warnings. The user should read through this complete document before using the MS-100. Ensure you read all information contained in this manual before using the READ MS-100.
Safety Stickers There is a safety and information panel provided on the Clamp Arm (see images below) of the MS-100 to alert the user of potential safety risks/hazards. Please read and adhere to all instructions on the Unit. It is forbidden to remove any safety or instructional stickers or panels from the MS-100.
WARRANTY: (Ex-factory/ Reseller premise) MAKINEX warrants to the original purchaser: MAKINEX provides a Limited One Year Warranty that applies to MS-100 Mixing Station only (this excludes the Stirrer/mixer and any other attachments and consumables). Any unauthorized repair or part replacement will void warranty. Refer to manufacturer for all repairs.
Page 7
All warranties will be carried out by MAKINEX authorised staff or appointed agents at a premises to be determined by the Manufacturer. It is the responsibility (and cost) of MAKINEX or our appointed agent to return the machine to be repaired or replaced under warranty to the consumer- this is valid for domestic territories only (e.g.
Page 8
AUS: 1300 795 953 or +61 2 9460 8071 USA: 855-625-4639 EUROPE: +31 (0)6 24881203 or +31 (0)6 50841849 Or your nearest MAKINEX distributor We have very knowledgeable, experienced staff to assist you with help and advice. MAKINEX MS-100 – Operator’s Manual Page 8 of 16...
One MS-100 mixing station can mix up to 80kg in 3 minutes, which can equate to 1 Tonne per hour. MS-100 is ultra-lightweight for easy transportation and the ergonomic design with easy-tilt operation provides control and speed for precision pouring.
INSTRUCTIONS FOR USE Do Not Operate the MS-100 without wearing the appropriate personal protective equipment (PPE) including appropriate footwear. WARNING Assess the surrounding area for hazards. ALWAYS seek appropriate First Aid if Injury, Poisoning or Irritation occurs due to contact with Materials and Substances.
Page 11
3. Attach MS-100 ‘Clamp Arm’ into the ‘Slide Arm Collar’ of the MS-100 Frame; tighten ‘Collar Latch’ in place. Clamp Arm Collar Latch Slide Arm Collar 4. When fitting a mixer, make sure the slider’s opened, fit it through the gap from the front...
Page 12
If fitting the Protool® Stirrer, ensure the Variable If fitting the Collomix® Mixer, ensure the Speed Dial is facing away from the MS-100 Electrical Cord is facing to back of the Handle. MS-100. MAKINEX MS-100 – Operator’s Manual Page 12 of 16...
ALWAYS disconnect Stirrer/Mixer from mains power before placing hands WARNING into the Bucket. ALWAYS ensure the Stirrer/Mixer is switched OFF before plugging it in. ALWAYS wind-up the Power Cord before moving the MS-100. ALWAYS be aware of the Power/Extension Cord position when working WARNING around the MS-100™.
Page 14
Wheel MS-100 to the desired area (use caution when moving the Loaded Bucket). Disengage (unlock) ‘Locking Pin’ at the base of the Bucket. Using a controlled motion (use the ‘MS-100 Handle and Pouring Handle) pour mixed Levelling Compound where required.
NOTE: and for more information. SALES & SPARES For sales and spare parts for all MAKINEX products; please refer to your local distributor. SERVICE & PART ORDERING For service and ordering parts, please call AUS: 1300 795 953 or +61 2 9460 8071...