Installation - Toshiba TW-BH95M4PH Owner's Manual

INSTALLATION

Installation
Installation area
！ Warning!
• Stability is important to prevent the product from
moving!
• Make sure that the product does not stand on
the power cord.
Before installing the machine, the location characterized
as follows shall be selected:
1.Rigid, dry, and level surface
2.Avoid direct sunlight
3.Sufficient ventilation
4.Room temperature is above 0 C
5.Keep far away from the heat resources such as coal or gas.
Unpacking the washing machine
！ Warning!
• Packaging material (e.g. Films, Styrofoam) can be
dangerous to children.
• There is a risk of suffocation ! Keep all packaging
materials well away from children.
1. Remove the cardboard box and styrofoam packing.
2. Lift the washing machine and remove the base packing.
foam is removed together with the bottom foam. If not, lay the unit down on its side,
then remove the small foam from the unit bottom manually.
3. Remove the tape securing the power supply cord and drain hose.
4. Remove the inlet hose from the drum.
Remove transport bolts
！ Warning!
• You must remove the transport bolts from the back, before using the product.
• You'll need the transport bolts again if you will transport the product , so
make sure you keep them in a safe place.
Please do the following steps to remove the bolts:
1.Loosen 4 bolts with spanner and then remove them.
2.Cover the holes with transport hole plugs.
3.Keep the transport bolts properly,for future use.
°
10
w
W 20mm
>
Make sure the small
w
triangle