Table of Contents
Advertisement
e． Insert the door bush into the round hole
on the door and then put on the small end cap
cover.
f． Move the refrigerator door upward over
500mm to remove the door.
2.
a． Use a tool to remove the 3 screws off
the middle hinge cover and then remove the
middle hinge.
b． move the freezer door upward over
500mm to remove the door.
c． Remove the adjustable front feet under
the lower hinge; use a tool to remove the 4
screws from the lower hinge and then
disassemble the lower hinge. Door disassembly
is finished.
Assemble door, lower hinge
accessories to the corresponding
positions
1.
a． Use a tool to get the door bush out as
shown in the below figure and assemble it to
the corresponding position of the other side.
b． Use a tool to remove the screws off the
stopper ass as shown in the below figure and
then assemble them to the other side of the
door.
c． Use a tool to remove the
stoppers on the lower hinge and then
assemble them to the position as shown in the
below figure.
Assemble the refrigerator door and
freezer door to the opposite side
1.
a． Remove the adjustable front foot as
shown below by hand and then assemble the
lower hinge to the other side of the cabinet
and fix the screws by using a tool.
b． Assemble the shorter adjustable front foot
to the lower hinge side and adjust the height
of the foot to make the refrigerator stay in
level.
2.
Put on the freezer door and turn the middle
hinge by 180 °C and then assemble it to the
other side of the cabinet; use a tool to screw
up the 3 screws to fix the middle hinge.
3.
Put on the refrigerator door and assemble
the upper hinge to the other side of the
cabinet; use a tool to screw up the 4 screws to
fix the upper hinge.
4.
After that, connect the door
communication line and the cabinet
communication line and then put on the upper
hinge cover and fix it using a screw.
Assemble the hole cover to the other side of
the cabinet and use a tool to screw up the hole
cover.
Door disassembly is finished here.
Double check that the door is aligned correctly and
all the seals are closed on all sides. If necessary, re-
adjust the levelling feet.
axle
and two
NOTE: If you want to have the door swing reversed,
we recommend that your contact a qualified
technician. You should only try to reverse the door
yourself if you believe that you are qualified to do so.
All parts removed must be saved to do the
reinstallation of the door. You should rest the fridge
freezer on something solid so that it will not slip
during the door change process. Do not lay the fridge
freezer flat as this may damage the coolant system.
Ensure the fridge freezer is unplugged and empty.
We recommend that 2 people handle the fridge
freezer during assembly.
TROUBLE SHOOTING
If the appliance does not operate when switched on,
check.
Power cut: If the internal temperature of the
Fridge/Freezer compartment is -18°C or less when
the power returns, your food is safe. The food in your
Fridge/Freezer will remain frozen for approx 16
hours with the door closed. Do not open the
Fridge/Freezer door more than necessary.
The product is designed and built for domestic
household use only.
The plug is inserted properly in the socket and that
the power supply is on. (To check the power supply
to the socket, plug in another appliance).
The fuse has blown/circuit breaker has tripped/main
distribution switch has been turned off.
The temperature control has been set correctly.
If the refrigerator is exceptionally cold, you may have
accidentally adjusted the thermostat control dial to a
higher position.
If the refrigerator is exceptionally warm, the
compressor may not be working. Turn the
thermostat control dial to the maximum setting and
wait a few minutes. If there is no humming noise, it is
not working. Contact the local store where your
purchase was made.
If condensation appears outside of the Refrigerator,
this may be due to a change in the room
temperature. Wipe off any residue of moisture. If the
problem continues contact the local store where
your purchase was made.
If the provided plug has been replaced make sure the
new plug is properly connected. If the appliance is
still not operating after the above checks, please
contact Customers Service.
SCRAPPING OLD APPLIANCES
This appliance is marked according to the European
directive 2012/19/EU on Waste Electrical and
Electronic Equipment (WEEE).
31
Advertisement
Table of Contents
