USB-2.0 internal Hub
Installation and Use
Benutzerhandbuch
LINDY Art. Nr. 32882
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - Aug 2002
English Manual
General Features
•
4 ports USB 2.0 Hub
•
With panel for an easy insertion into a 3½" or 5¼" front bay
•
Convienient front acces to USB ports
•
For PC and MAC
•
Compliant with Plug & Play specification
•
No software driver required
USB features
•
Fully compatible with the USB OHCI/UHCI/EHCI
specification and with USB v. 2.0/1.1
•
Data transfer rate of 480 Mbit/s maximum
•
English
Supports all kinds of USB devices
Deutsch
Hardware requirements
•
USB port
•
An empty 3½" or 5¼" bay
Software requirements
•
Windows: 98SE / ME / 2k / XP
•
Mac OS8.6 or higher
Package contents
•
3½" internal Hub with 5¼" conversion case
•
This manual
•
0.8m USB 2.0 A Tyoe cable
•
power cable
•
Dented slotplate (to connect cables to the rear ports)
•
Mounting screws
•
Plastic cable holder
Please check the content carefully.
Installation
1.
Ensure that the computer is turned off and all cables are
disconnected.
2.
Open your computer and remove a 3½" or 5¼" front bay
cover.
3.
Insert the hub into the empty space and fix it in securely
using the small 4 screws provided.
4.
follow the cable connection instructions below.
English Manual
Cable connection
Power cable: Ensure that the coloured wires of the cable are (from
left to right) Pin 4 to Pin 1.Connect the Y power cable to an
available connector on the power supply. The other end of the
cable may be used to attach another device.
USB cable: Use either a present internal USB port or do the
following:
After having removed one of the slot plates of the computer
connect the small USB port connector to the Hub as shown in the
figure above. Ensure that the coloured wires of the cable are
(from left to right) Pin 4 to Pin 1. After the cable has been leaded
through the rear slot plate space, insert the provided slot plate and
put the cables into the notch. Then fix the slot plate with the large
screw and insert the USB cable into the USB port of the computer.
Close the computer case.
USB 2.0 Hub Software Installation
The computer will recognize the Hub by itself. Just follow the
instructions on the screen!
FCC Compliance Statement (United States)