Advertisement
The machine will not stop
This is a very rare occurrence as the machine is designed to be fail-safe. If it
should occur and you cannot fix the fault, seek professional assistance. The
machine must be disconnected from the power and never run until the fault
has been rectified.
1.
Stop switch faulty. Replace the stop switch.
2.
Internal breaker faulty. Replace the breaker.
Motor tries to start, but will not turn
1.
With the power disconnected from the machine, try to turn the spindle
by hand. If the spindle will not turn, check the reason for the jamming.
2.
Capacitor faulty. Replace the capacitor.
3.
Motor faulty. Replace the motor.
Motor overheats
The motor is designed to run hot, but should it overheat, it has an internal
thermal overload protector that will shut it down until the motor has cooled,
and then it will reset automatically. If the motor overheats, wait until it has
cooled and restart. If the motor shuts down consistently, check for the
reason. Typical reasons are dull cutting tools, motor cooling fan clogged or
faulty, overfeeding the job and excessive ambient temperature.
Squeaking noise
1.
Check that the motor cooling fan is not contacting the fan cover.
2.
Check the bearings.
Spindle slows down during a cut
1.
Dull cutting tools. Replace the tool or have it re-sharpened.
2.
Feeding the wood too fast. Slow down the feed rate.
Machine vibrates
1.
Machine not level on the floor. Re-level the machine ensuring that it
has no movement.
Accessories
The following accessories are available from Laguna Tools:
-
Various drills and cutting tools.
-
Additional job clamps.
-
Additional job setting stops
-
Tool cabinet [floor standing].
-
Toolbox
-
Work Benches
16
Advertisement
