Advertisement
top and bottom. Clear the blockage if required. If the grey swivel is
disconnected, ensure the stainless steel washer is present inside the
swivel before pushing it firmly back onto the cleaner.
•
Check there is sufficient tread on the tracks of the cleaner and
replace if required.
•
Turn off your pump and remove the cleaner from the pool. Lay on a
flat surface, and gently with two hands, check the tracks can move
back and forth. If there is an issue, consult your local pool professional.
If your rX-Tank is floating or hovering in your pool
•
Check if your cleaner has air trapped in the Halo. Air bubbles will
be visible in the chambers. To remove trapped air, hold the cleaner
under water and gently squeeze each chamber that has visible air
bubbles to release the air and fill entirely with water.
Cleaner is turning in circles
•
Turn off the pump and remove the cleaner from the pool. Check the
tracks can move freely both sides. If one or both is jammed,
or an audible rough noise can be heard, please consult your local
pool professional.
rX-Tank is climbing out of the pool
•
Check if the tracks are worn. Replace parts as required.
•
Ensure your Halo is fitted to the rX-Tank. Reinstall if required.
•
You may have too much vacuum going to the cleaner. Check your
Smart-Skim or Auto Skim is installed and moving freely. Replace
spring on Smart-Skim if required. Try cleaning Auto Skim in clean
water by moving the collar up and down to flush out debris. If stiff
or damaged, you may need to replace your AutoSkim.
10
rX-Tank_manual_V12.indd 10
14/10/19 1:20 pm
Advertisement
