Connecting A High-Definition (Hd) Source; Connecting A Pc - Venturer PLV36199S1 Instruction Manual

CONNECTING A HIGH-DEFINITION (HD) SOURCE

High-Definition (HD) Devices with component video output must be connected to the YUV input.
Connect the component video cable and audio cable (not included) as shown.
Make sure you connect the component video cable and audio cable from the other equipment (COMPONENT
VIDEO OUT and AUDIO OUT) to this unit (COMPONENT VIDEO IN and AUDIO IN - YUV IN).
* May require a subscription
for receiving HD channels.
Check with your cable/
satellite service provider for
details.
NOTE
When connecting a DVD player to the television, the picture resolution is solely dependent upon the resolution
supported by the DVD player attached. DVD player resolutions vary from 480i to 1080i, and this unit can
support DVD players up to a maximum resolution of 1080i.

CONNECTING A PC

Connect the 15-pin D-SUB PC/VGA connector from your computer to the 15-pin D-SUB PC/VGA input on
this unit using a monitor cable and an audio cable (not included) as shown.
Make sure you connect the
cable from the computer (PC
Connector and AUDIO - PC
OUT) to this unit (MONITOR /
VGA and AUDIO - PC IN).
PLV36199.indd 9
CONNECTIONS
To AUDIO
IN jacks
(YUV IN)
COMPONENT
VIDEO IN
To COMPONENT
VIDEO IN jacks
(YUV IN)
E - 9
HD SOURCE
With component video output
(Digital Cable Box*, Satellite
Receiver*, or external
over-the-air HD-Tuner).
To AUDIO
OUT jacks
COMPONENT
VIDEO OUT
To COMPONENT
VIDEO OUT jacks
To AUDIO jack (PC OUT)
To PC connector
8/28/2007 3:15:42 PM