Electrolux SP185H42LT Operator's Manual page 9

18.5 hp 42 inch
Table of Contents

Advertisement

For Parts Call K&T 606-678-9623 or 606-561-4983
7. Slide seat until a comfortable position
is reached which allows you to press
clutch/brake pedal all the way down.
8. Get off seat without moving its ad-
just ed position.
9. Raise seat and tighten adjustment
knob securely.
Seat Pan
Flat Washer
Adjustment Knob
CHECK BATTERY
1. Lift seat pan to raised position.
NOTE: If this battery is put into service
after month and year indicated on label
(label located between terminals) charge
battery for minimum of one hour at 6-10
amps. (See "BATTERY" in Maintenance
section of this manual for charging instruc-
tions).
Seat pan
Terminal
02602
NOTE: You may now roll or drive your
tractor off the skid. Follow the ap pro pri ate
instruction below to remove the tractor
from the skid.
TO ROLL TRACTOR OFF SKID (See
Op er a tion section for location and
function of con trols)
1. Press lift lever plunger and raise
attachment lift lever to its highest po-
si tion.
2. Release parking brake by de press ing
clutch/brake ped al.
3. Place freewheel control in "trans-
mis sion disengaged" position (See "TO
TRANS PORT" in the Op er a tion section
of this manual).
4. Roll tractor forward off skid.
5. Remove banding holding defl ector
TO DRIVE TRAC TOR OFF SKID (See
Op er a tion section for location and
function of con trols)
der stand and fol low all in struc tions in the
Seat
Op er a tion section of this man u al. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
peo ple and objects.
1. Be sure all the above assembly steps
Shoulder
2. Check engine oil level and fi ll fuel tank
Bolts
3. Place freewheel control in "trans-
4. Sit on seat in operating position,
02615
5. Place motion control lever in neutral
6. Press lift lever plunger and raise
7. Start the engine. After engine has
8. Release parking brake.
9. Slowly move the mo tion control lever
10. Apply brake to stop trac tor, set park ing
Label
11. Turn ignition key to "STOP" position.
Terminal
Continue with the in struc tions that follow.
9
www.mymowerparts.com
shield up against tractor.
WARNING: Before start ing, read, un-
have been completed.
with gasoline.
mis sion engaged" position. (See "TO
TRANS PORT" in the Op er a tion section
of this manual).
depress clutch/brake pedal and set the
parking brake.
(N) position.
attachment lift lever to its highest posi-
tion.
started, move throttle control to idle
position.
for ward and slowly drive tractor off
skid.
brake and place motion con trol lever in
neutral po si tion.

Advertisement

Table of Contents
loading

Table of Contents