Electrolux SP185H42LT Operator's Manual page 29

For Parts Call K&T 606-678-9623 or 606-561-4983
TROUBLESHOOTING CHART:
PROBLEM CAUSE
Loss of power 5. Low oil level/dirty oil.
(continued) 6. Faulty spark plug.
7. Dirty fuel fi lter.
8. Stale or dirty fuel.
9. Water in fuel.
10. Spark plug wire loose.
11. Dirty engine air screen/fi ns.
12. Dirty/clogged muffl er.
13. Loose or damaged wiring.
14. Carburetor out of adjustment. 14. See "To Adjust Carburetor" in
15. Engine valves out of
Excessive 1. Worn, bent or loose blade.
vibration
2. Bent blade mandrel.
3. Loose/damaged part(s).
Engine dies when 1. Reverse operation system
tractor is shifted
into reverse
Engine continues 1. Faulty operator-safety
to run when oper-
ator leaves seat
with attachment
clutch engaged
Poor cut - uneven 1. Worn, bent or loose blade.
2. Mower deck not level.
3. Buildup of grass, leaves, and 3. Clean underside of mower
4. Bent blade mandrel.
5. Clogged mower deck vent
adjustment.
(ROS) is not "ON" while
mower or other attachment
is engaged.
presence control system.
trash under mower.
from build-up of grass, leaves,
and trash around mandrels.
29
www.mymowerparts.com
CORRECTION
5. Check oil level/change oil.
6. Clean and regap or change
spark plug.
7. Replace fuel fi lter.
8. Empty fuel tank and refi ll tank
with fresh, clean gas o line.
9. Empty fuel tank and car-
buretor, refi ll tank with fresh
gasoline and replace fuel fi lter.
10. Connect and tighten spark
plug wire.
11. Clean engine air screen/fi ns
12. Clean/replace muffl er.
13. Check all wiring.
Service and Adjustments
section.
15. Contact our authorized
service center/department.
1. Replace blade. Tighten
blade bolt.
2. Contact our authorized
service center/department.
3. Tighten loose part(s).
Replace damaged parts.
1. Turn ignition key to
ROS "ON" position.
See Operation section.
1. Check wiring, switches and
connections. If not cor rect ed,
contact our authorized
service center/department.
1. Replace blade. Tighten
blade bolt.
2. Level mower deck.
housing.
4. Contact our authorized
service center/department.
5. Clean around man drels to
open vent holes.