Toro Reelmaster 7000-D Service Manual page 179

Removal (Fig. 66)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Read the General Precautions for Removing and
Installing Hydraulic System Components at the begin-
ning of this chapter.
3. To prevent contamination of hydraulic system during
rear axle motor removal, thoroughly clean exterior of
motor.
4. Disconnect wire harness connector from the temper-
ature sender (item 17) on the rear axle motor.
5. Disconnect hydraulic lines from motor. Put caps or
plugs on lines and fittings to prevent contamination. La-
bel the hydraulic hoses to show their correct position on
the axle motor for assembly purposes.
IMPORTANT: Support axle motor to prevent motor
from falling during removal.
6. Remove rear axle motor.
7. Remove and discard O- ring (item 2) from flange of
wheel motor.
8. If hydraulic fittings are to be removed from axle mo-
tor, mark fitting orientation to allow correct assembly.
Remove fittings from motor and discard O- rings.
9. If necessary, remove retaining rings and pinion gear
(item 3) from motor shaft.
Reelmaster 7000- D
Installation (Fig. 66)
1. If fittings were removed from axle motor, lubricate
and place new O- rings onto fittings. Install fittings into
motor ports using marks made during the removal pro-
cess to properly orientate fittings. Tighten fittings (see
Hydraulic Fitting Installation in this chapter).
2. If removed, install pinion gear to axle motor. Make
sure that snap rings are fully seated into the motor shaft
grooves.
3. Install new O- ring (item 2) onto motor. Position mo-
tor to rear axle assembly, align gear teeth and slide mo-
tor into place.
4. Secure motor to axle with cap screws and flat wash-
ers.
5. Remove plugs from lines and fittings. Attach hydrau-
lic lines to rear axle motor (see Hydraulic Hose and Tube
Installation in this chapter).
6. Connect wire harness connector to the temperature
sender (item 17) on the rear axle motor.
7. Fill hydraulic reservoir with hydraulic fluid as re-
quired.
8. After assembly is completed, verify that hydraulic
lines and fittings do not contact any hot or moving parts.
Page 5 - 109 Hydraulic System