Ultimus
I–II High Precision
™
Fluid Dispensers
Quick Start Guide
Electronic pdf files of Nordson EFD manuals are also available at www.nordsonefd.com.
Easy 13-Step Setup
Follow these steps to get your Ultimus ready
for operation.
Unpack the Unit / Warranty
• Unpack the unit.
1
• Now is a good time to activate your Five* Year No-Fault Warranty.
Install Barrel Holder
• Remove barrel holder sleeve from holder. ò
2
• Loosen the 6 mm screw from T-nut. ù
• Slide T-nut into left or right panel of workstation
• Tighten 6 mm screw, securing holder to workstation
• Insert barrel holder sleeve. ö
• Loosen screw from wire hose holder T-nut. ü
• Slide T-nut into any workstation slot. Å
• Tighten screw to secure wire hose holder to
Connect Power
3
• Connect the power plug to the power pack. The unit is shipped
• Connect the power cord to the back of the Ultimus.
• Connect the power cord to your local power source.
• Press the power button on the front panel.
Register the warranty online at
*Two years in Asia
slot, positioning as shown. ä
panel. ë
workstation. î
with a USA-compatible plug and three international plugs. Attach
the correct plug to match local power outlets.
www.nordsonefd.com/warranty/five-no-fault.
ò
ä
.
ù
Å
ü
Power cord
î
ë
ö