Advertisement
4.
Sliding the appliance into
ã
Caution:
Be careful when sliding the appliance into the
installation niche. Do not damage the water
connection or power cord.
Note:
If the floor or appliance is skew in relation to the
installation niche, the height-adjustable wheels sh
be correspondingly adjust
appliance into the niche.
1.
Remove the base panelling.
2.
Unscrew the height-adjustable feet at the back of
the appliance by approx. 10 mm.
3.
Plug the mains plug into the socket.
4.
Insert water connection line into the protective p
on the rear of the appliance.
ã
Warning:
The appliance may tilt when the water
connection line is inserted into the protective
pipe (a)!
14
the installation niche
ould
ed before sliding the
5.
Protect the mains lead from getting wedged under
or behind the appliance.
Recommended procedure:
Tie a piece of string in the middle of the power co
and guide the string forwards over the appliance.
When pushing the appliance
cable upwards with the string.
or
Fasten the mains lead onto the floor with adhesive
tape, in the middle behind the appliance approx.
38 cm from the rear of the niche.
6.
Slide the appliance carefully into the niche.
7.
Remove edge protection from the installation cavi
(if previously attached).
ipe
rd
into the cavity, pull the
ty
Advertisement
