Bosch CIB36 Series Installation Instructions Manual page 13

2. Attaching alternative anti-tilt
device
Important note:
If the anti-tilt brackets cann
wooden beam can be used above the appliance as an
alternative anti-tilt device.
there is not a gap between the appliance and the
wooden beam. As far as possible, always screw the
wooden plank to the rear wall of the niche.
1. Cut the wooden plank to the required length (cross
section min. 8 x 10 cm). The length should
correspond to the width of
Note:


ot be securely attached, a
Care should be taken that
the installation niche!

13