Install The Fan - NuTone CFO52BQ Instructions Manual

INSTALL THE FAN

NOTE: This ceiling fan is supplied with long and short downrods. Use
the long downrod for standard ceiling heights. Use the short downrod in
rooms with less than 8-feet ceilings or in areas where additional space
is desired from the floor to the fan blades.
1. Pass the 120-volt supply wires through the center hole in the ceiling
hanger bracket as shown in Fig. 5.
2. Secure the hanger bracket to the ceiling outlet box with the screws
and washers provided with your outlet box.
3. Remove the hanger pin, lock pin and set screws from the downrod
assembly.
4. Route wires exiting from the top of the fan motor through the canopy
and then through the ball/downrod and rubber ball cover. (Fig. 6)
5. Align the holes at the bottom of the downrod with the holes in the
collar on top of the motor housing. Carefully insert the hanger pin
through the holes in the collar and downrod. Be careful not to jam
the pin against the wiring inside the downrod. Insert the lock pin
through the hole near the end of the hanger pin until it snaps into
its locked position. (Fig. 6)
6. Tighten two set screws on top of the fan motor firmly.
7. Place the downrod ball into the hanger bracket socket. This will
allow you to make the electrical connections. (Fig. 7)
MODELS CFO52BQ • CFO52WB • CFO52WH
UL LISTED
ELECTRICAL
BOX
CEILING
HANGER
BRACKET
HOOK
120V WIRES
RUBBER
BALL COVER
DOWNROD
RUBBER
YOKE COVER
HANGER
PIN
REGISTRATION
SLOT
MOUNTING
SCREWS
(SUPPLIED WITH
ELECTRICAL BOX)
FIGURE 5
DOWNROD
BALL
CANOPY
SET SCREWS
FIGURE 6
FIGURE 7
Page 3
WASHERS
LOCK
PIN