Load Wheel; Removal; Repair; Load Wheel Installation - Blue Giant EPJ-30 Owner's Manual

7-3. Load Wheel.

7-3.1. Removal

1. Raise forks.
2. Turn off the key switch (23,
emergency disconnect (20).
3. Block the drive wheel to prevent the truck from
rolling.
4. Jack up the forks to raise the load wheels off the
floor. Securely block the forks in the raised posi-
tion by positioning supports under both fork tips.
NOTE: When shaft (12,
load wheel assembly (13) will drop free.
5. Remove pin (11) securing shaft (12) and remove
shaft (12) and load wheel assembly (13).
NOTE: Inspect the load wheel assembly. If the load
wheel is worn within 1/8" of the metal sleeve,
or is cracked or damaged, replace the entire
load wheel and bearing assembly. Blue
Giant
recommends
wheel assemblies
same time. This ensures level and safe
operation of the lift truck.
R6607
Figure 12-16) and
Figure 12-11) is removed,
that both
be replaced at
Figure 7-2 Wheel Assembly

7-3.2. Repair

1. Remove bearings (1,
2. Inspect bearings (1) and replace if necessary.
3. Reassemble bearings (1) in wheels (2).

7-3.3. Load Wheel Installation

1. Position load wheel assembly (13,
in wheel bracket (12).
2. Install shaft (12) and secure with pin (11).
3. Remove blocking from under the truck.
4. Lower the forks.
5. Turn on the key switch (23,
emergency disconnect (20).
load
the
Figure 7-2) from wheels (2).
Figure 12-11)
Figure 12-16) and
43