Standard FLUO LED 120 V Installation Manual

Table of Contents

Download this manual

Installation guide

FLUO LED

120 V

Read the installation instructions and all product labels before proceeding with the installation. This product must

be installed in full accordance with applicable electrical and building codes. Installation should be performed by

a qualified electrician in accordance with the Canadian national electrical standards and relevant local codes.

TO PREVENT ELECTRICAL SHOCK, POWER SHOULD BE TURNED OFF FROM THE ELECTRICAL PANEL BEFORE INSTALLATION

OR MAINTENANCE.

SAFETY WARNINGS

• Suitable for use in damp locations.

• Use only on 120 VAC, 60 Hz circuits.

• Operating temperatures: -20 °C to 40 °C (-4 °F to 104 °F)

• 5 year limited warranty.

• For complete dimmer compatibility and warranty information visit www.standardpro.com

End to End connector (1 unit)

Fixing Clips (2 units)

Screws (2 units)

Table of Contents

Do you have a question about the FLUO LED 120 V and is the answer not in the manual?

Page 1 Installation guide FLUO LED 120 V Read the installation instructions and all product labels before proceeding with the installation. This product must be installed in full accordance with applicable electrical and building codes. Installation should be performed by a qualified electrician in accordance with the Canadian national electrical standards and relevant local codes. TO PREVENT ELECTRICAL SHOCK, POWER SHOULD BE TURNED OFF FROM THE ELECTRICAL PANEL BEFORE INSTALLATION OR MAINTENANCE.
Page 2 Installation guide FLUO LED 120 V INSTALLATION – STEPS Turn OFF the power before proceeding with the installation. PLUG-IN INSTALLATION 1. Attach the power cord to the "INPUT" receptacle on one end of the luminaire. Do not force connection, it should snap in easily.
Page 3 ETE-01 Approved for installation inside, under or over cabinets, with light shining in any directions Linears Installation guide FLUO LED 120 V Lumen Total per ﬁxture consumption e electronic dimmers LEDT5-5W 300-350lm allation inside, under or over cabinets, with light shining in any directions Linears can be directly connected on to junction box, or be used with an extension c LEDT5-8W 480-560lm...