Standard LED SHOPLIGHT Installation Instructions

LED SHOPLIGHT

INSTALLATION INSTRUCTIONS

IMPORTANT - READ ALL INSTRUCTIONS BEFORE INSTALLATION
• Installation and maintenance must be performed by licensed electricians only.
• To avoid risk of electric shock, make sure to turn off main power switch prior to installation or maintenance.
• Must be installed in compliance with National Electrical Code (NEC) in the US or Canadian Electrical Code in Canada.
• Ensure input voltage and frequency are compatible with the fixture. Check product manual for power requirements prior to installation.
CAUTION
• Before installation inspect luminaire for any exterior damages or other defects.
• Before installation confirm luminaire is the correct rated voltage for application.
• During installation do not damage luminaire with drill or external impact.
• Do not expose luminaire directly to high heat.
• Beware of shock when installing luminaire.
• Do not install in areas where flooding may occur.
• Do not clean or expose the luminaire to detergent, chemical cleaners or pesticides.
• Upon completion of installation, ensure the luminaire is tight and secure.
• Turn power off when disassembling.
• Do not look directly into LED luminaire when lit.
• Do not exchange components in luminaire.
• Do not operate the fixture where ambient temperature is over 40°C or in confined spaces. This is a fire hazard.
• Do not install luminaire in applications where high vibrations or external shock are present.
• Do not install/operate luminaire in areas where salt content in the air and soil could cause the luminaire to corrode.
• Do not install luminaire in areas where corrosive substances are present.
• Do not install luminaire in areas where organic debris can accumulate on luminaire (example: fallen leaves, insects).
• This luminaire is designed to operate horizontally mounted with the LEDs facing down.
• In the event of product failure resulting from negligence of above mentioned instructions, limited warranty will not be applicable.

INCLUDED IN THE BOX

(A)
(B)

SPECIFICATIONS

Volts (V): 120
Frequency (Hz): 60
Watts (W): 40
Input current (mA): 343.5
Weight: 1.45 kg /3.2lbs
Mounting options: Surface or suspended with aircraft cables (included)
(C)
C) (D)
LUMINAIRE DIMENSION
Length: 47.28'' (120 cm)
Width: 4.80'' (12.2 cm)
Depth: 1.42'' (3.6 cm)
Aircraft cables: 6' (1.80 m)