Standard Hardwire Junction Box 120V Installation Manual

Installation guide
Hardwire Junction Box 120V
Read the installation instructions and all product labels before proceeding with the installation. This product must
be installed in full accordance with applicable electrical and building codes. Installation should be performed by
a qualified electrician in accordance with the Canadian national electrical standards and relevant local codes.
TO PREVENT ELECTRICAL SHOCK, POWER SHOULD BE TURNED OFF FROM THE ELECTRICAL PANEL BEFORE INSTALLATION
OR MAINTENANCE.
SAFETY WARNINGS
• Do not exceed the nominal supply voltage or amperage rating.
• This device is not intended for use with emergency exit fixtures or emergency exit lights.
• Operating Temperature: -20°C to 40°C (-4°F to 104°F)
• 5 year limited warranty.
1
COMPONENTS
B
1 X HardWire Junction Box
INSTALLATION – STEPS
Turn OFF the power before proceeding with the installation.
1. Remove Junction Box cover screws (4) and remove cover. (Figure 1)
2. Install the 3/8" strain relief connector through the knockout at the back of the junction box.
3. Pass the 120 V wires through this connector and into the junction box.
4. Tighten the strain relief connector's screws to hold the 120 V wires in place.
5. Fix the junction box underneath the cabinets with the provided screws.
6. Make electrical connections matching wire colors (black to black and white to white) and secure with the
provided wire nuts. (Figure 2)
E
名称 签名 日期
绘制
2 3
2 X Fixing
Screws
110
标题:
佛山市南海立博照明电器有限公司
4
A
B
3 X Wagos /
Quick connect
C
D
E
1 X Strain relief connector