Advertisement
Installing/Removing the Rack Rear-Extension Kit
1. Remove the rear door, hinges, lock bracket, and rear under bar.
Refer to the rack user's guide before removing.
2. Hook the right/left frames on the rack and temporarily attach them to the rack with hex screws.
Screws are 12 pieces in total.
Note: Pre-drilling threaded holes with a tapping screw will make it easier to attach the right/left
frames to the rack.
3. Attach the top frame with 6 screws and secure with all screws.
Note: When attach the top frame, first, tighten hex screws, second, tighten decorative screws.
4. Reattach the rear under bar, lock bracket, hinges and rear door.
Refer to the rack user's guide before installation.
Step 1
Hinges
Rear door
Step 4
Duct cover
Top frame
Hinge
Right frame
Duct cover
Hinge
Rear door
Note: This product is delivered with the duct cover installed.
Normally, the duct cover does not need to be removed.
The duct cover should only be removed when necessary for cable work, etc.
Rear frame
Lock bracket
Rear under bar
Lock bracket
Left frame
Rear under bar
Step 2
Hook
M5 Hex screws
2pcs x 3places
Step 3
Top frame
Rear frame
Right frame
- 7 -
N8140-801/802/803/804 奥行き延長キット/Rack Rear-Extension Kit
- 8 -
N8140-801/802/803/804 奥行き延長キット/Rack Rear-Extension Kit
Left frame
Hook
M5 Hex screws
2pcs x 3places
Hook
Right frame
Hook
Rear frame
Decorative screws
2pcs
Left frame
M5 Hex screws 4pcs
856-129341-801- A Rev.3
Memo
856-129341-801- A Rev.3
Advertisement
