Cisco ASR 9000 Series Manual page 23

Replacing Cisco ASR 9000 Series Router Components
Figure 16: Removing a Power Tray –Version 2 Power Tray (Cisco ASR 9010 Router Shown)
1
Step 8
Rotate the ejector levers away from the tray to unseat the tray from its mating connector. The figure Removing
a Power Tray—Version 1 Power Tray shows the process for the version 1 power trays, and the figure Removing
a Power Tray –Version 2 Power Trayshows the process for the version 2 and version 3 power trays.
Step 9 Slide the power tray out of the bay of the chassis.
Installing an AC or DC Power Tray into a Cisco ASR 9000 Series Router
Follow these steps to install an AC or DC power tray into the chassis:
Procedure
Step 1
Slide the power tray into the bay until it engages its mating connector on the chassis. The ejector levers will
partly rotate inward as you do this.
Step 2
Fully rotate the ejector levers inward to fully seat the power tray into its mating connector and seat the power
tray mounting ears against the chassis mounting ears. The figure Rotating the Ejector Levers Inward to Seat
the Version 1 Power Tray shows how to install the version 1 power trays and the figure Rotating the Ejector
Levers Inward to Seat the Version 2 Power Tray shows how to install the version 2 power trays. The installation
of version 3 power trays is similar to the installation of version 2 power trays, as shown in the figure Rotating
the Ejector Levers Inward to Seat the Version 2 Power Tray. When the power tray is fully seated, the captive
screw in each ejector aligns with the screw hole in the power tray frame.
Remove screws 2
on each side that
secure the power
tray to the
chassis
Installing an AC or DC Power Tray into a Cisco ASR 9000 Series Router
Loosen the 3
captive screw in
each ejector
lever
Replacing Cisco ASR 9000 Series Router Components
Rotate the
ejector levers out
to unseat the tray
from its mating
connector
23