1. Go to the Setup-Outputs group and select the PDU8-1 and PDU8-2 tabs.
2. Review the pinout table for VCU functions for each output channels. These output
functions are not re-assignable.
3. Manual override settings are available for testing each output. Set the _OvrVal to 1
then set the _OvrSts to override to override the the output logic.
4. Refer to the user instructions provided with the AEM PDU8 for more information on
hardware capabilities and wiring.
CAUTION!
Do not manually override high voltage contactor drivers when they are connected to the
battery pack.
6/3/2020, Revision C
AEM Performance Electronics
th
2205 W 126
Street, Unit A
Hawthorne, CA 90250
AEM EV VCU200 User Guide
Phone (8am-5pm M-F PST): 310-484-2322
Fax: 310-484-0152
sales@aemev.com
tech@aemev.com
Page 13 of 15