KTM 50 SX Setup Instructions page 5

2.1 Unpacking and setting up the vehicle
–
Open the box.
Info
To avoid damaging the vehicle while setting it up, do
not remove the protective film on each component until
installing the component, and leave it on the vehicle
until work has been completed.
–
Remove the separate enclosure and unpack it. Check that the
scope of supply is complete using the enclosed packing list.
201948-10
–
Lift the vehicle out of the box with the assistance of another
person.
–
Raise the motorcycle with a lift stand. (
–
Check the vehicle for transport damage.
–
Remove the protective film from the handlebar.
–
Position the handlebar with handlebar clamps.
–
Mount and tighten the screws.
Guideline
Screw, handlebar
clamp
–
Check the handlebar position.
» If the handlebar position is not adjusted as required by the
customer:
S00974-10
–
Adjust the handlebar position. (
–
Remove the screw of the brake line guide. Position the brake
line. Mount the brake line guide again and tighten the screw.
–
Check that the controls on the handlebar are correctly posi-
tioned and firmly seated.
–
Remove the seat. (
–
Remove the fuel tank. (
–
Position the service hour counter and fix it in place using an
adhesive pad.
–
Route the cable on the frame and attach it to the ignition wire.
Info
Do not kink or damage the cable.
–
Check that the wiring harness, throttle cables, and brake line
have the necessary freedom of movement and are correctly
E00751-01 routed.
–
Install the fuel tank. (
–
Mount the seat. (
p. 5)
M8 20 Nm (14.8 lbf ft)
p. 5)
p. 6)
p. 7)
p. 8)
p. 6)
SETUP 2
3