Unpacking; List Of Contents; Clean Up - General International 25-650ABC M1 Setup & Operation Manual

UNPACKING

Carefully unpack and remove the lathe components
from the box and check for damaged or missing items
as per the list of contents below.
NOTE: Please report any damaged or missing items to your
General International distributor immediately.

LIST OF CONTENTS

A - WOOD LATHE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
B - STAND CABINET . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
C - SPINDLE LOCK PIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
D - BELT TENSION RELEASE LEVER . . . . . . . . . . . . . . . . . . . . . .1
E - FACE PLATE WRENCH . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
F - TOOL REST SWIVEL ARM . . . . . . . . . . . . . . . . . . . . . . . . . .1
G - HEX HEAD BOLT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
H- KNOCK OUT BAR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
I - LEVELING FOOT W/NUT & JAM NUT . . . . . . . . . . . . . . . . .4
J - FLAT WASHER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
K - 12 /14 MM OPEN END WRENCH . . . . . . . . . . . . . . . . . . .1
L - SPUR CENTER* . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
M - FACE PLATE* . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
N - LIVE CENTER* . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
*Already installed on the lathe.
ADDITIONAL REQUIREMENTS FOR SET UP
• Help of 2 extra people
• Phillips screwdriver
• 14 mm socket wrench (optional)
• 12 mm socket wrench (optional)
• 6 mm Allen key
x2

CLEAN UP

The unpainted cast-iron surface of the lathe bed is covered with a protective coating that helps prevent rust from
forming during shipping and storage. Remove this protective coating by rubbing with a rag dipped in kerosene,
mineral spirits or paint thinner. (Handle and dispose of potentially flammable solvent soaked rags according to
manufacturers' safety recommendations.) Avoid rubbing the lathes painted surfaces as many solvent based prod-
ucts will remove paint.
To prevent rust, apply a light coating of paste wax or use regular applications of any after-market surface protec-
tant or rust inhibitor.
8
A
QTY
E
G
H
I
L
C
B
F
J
M
N
D
K