Mounting & Removing The Headstock Spur Center; Mounting & Removing The Tailstock Live Center; Moving Tailstock Quill In / Out - General International 25-650ABC M1 Setup & Operation Manual

MOUNTING & REMOVING THE HEADSTOCK SPUR CENTER
A
The headstock spindle has an MT#2 taper hole into
which the spur center fits A.
Note: The spur center can be installed with the face plate
B A
installed on or removed
section "Mounting a workpiece to the face plate" on page
15).
1. Make sure the shank of the spur center and the
spindle hole are clean and free of debris and fit
the spur center firmly in the spindle hole by hand.
MOUNTING & REMOVING THE TAILSTOCK LIVE CENTER
A
The tailstock has an MT#2 taper hole into which the live
center fits.
1. Make sure the shank of the live center and the tail-
stock hole are clean and free of debris and fit the
live center firmly in the hole by hand A.

MOVING TAILSTOCK QUILL IN / OUT

TAILSTOCK REAR VIEW
F
The tailstock quill can be moved in and out of the tail-
stock casting E by turning the tailstock quill movement
hand wheel F.
B
(to remove the face plate, see
E
D
C
To remove the headstock spur center:
Knock it out from the opposite end of the spindle D
using the supplied knock-out-bar C.
Note: When knocking out the spur center, always hold it by
hand to prevent it from falling
C
B
To remove the live center from the tailstock quill:
Loosen the tailstock quill locking lever B and move the
quill out by turning the quill movement hand wheel C
until the quill end is nearly inside the tailstock and the
live center can be removed by hand.
Note: When removing the live center, always hold it by
hand to prevent it from falling
To move the tailstock quill:
1. Loosen the quill locking lever G.
2. Turn the the quill movement hand wheel to move
the quill as needed.
3. Re-tighten the quill locking lever to secure the
quill in position.
E
E
.
D
D
.
G
13