Enabling/Disabling Fast Preview - AGFA CR 75.0 Reference Manual

Enabling/disabling fast preview

If fast preview is enabled, the Digitizer will transmit the digital image data to
the preview station as soon as you have entered the identification data. The
image data are sent in blocks of typical 100 lines. Fast preview permits you to
quickly assess whether the exposure was successful. As soon as the preview
image has been calculated, the fast preview image will be replaced by the
preview image. For more information, refer to the User manual of the ADC
Preview Software.
# Your service engineer can configure which station serves as preview
station. Either identifying and previewing images is done on the ID
station, or a dedicated station is reserved for previewing images. For
more information, contact your local service organization.
To enable or disable fast preview:
1
Check that the CR 75.0 is not scanning an image plate.
2
In the key-operator main menu, select 'Fast preview' via the Up and Down
keys.
Queue management
Digitizer set-up
Date and Time
Send test image
System info
Install
Save configuration
Fast preview
3
Confirm your choice.
The CR 75.0 will display:
Fast preview: enabled
2241A EN 20040210
KEY-OPERATOR
MENU
: quit
: ok
: select
SERVICE XXXXX
FAST
PREVIEW
: quit
: ok
: change
SERVICE XXXXX
73