Makita DFL651F Instruction Manual page 9

Function
Motor failure
Double-hitting detection
Maintenance alarm
Tool in connection with
PC (no data communica-
tion started/communica-
tion unavailable)
Tool in connection with
PC (data communication
started)
Adjusting the fastening torque
2
1
► 1 . Screw 2. Ring 3. Clutch case
1
► 1 . Scale 2. Hole for adjusting grip 3. Yellow line
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjust the
fastening torque as follows.
1. First remove the battery cartridge from the tool.
2. Remove the protector from the clutch case.
3. Loosen and remove the screw that secures ring.
Status
Motor failure has been Flickers in red and green
detected. At this time, alternatively.
tool does not work.
This function works Lights up in red.
when a screw is refas-
tened after fastening.
This function shows the Flickers in yellow.
maintenance time has
come according to your
preset number of screws
driven.
This function shows data Flickers in yellow.
cannot be exchanged
between the tool and
PC in spite of the
connection.
This function shows Flickers in green.
the tool is connected to
PC and data exchange
between the tool and PC
can be done in normal
conditions.
3
Status of the LED indicator/beeper
LED indicator
A series of short beeps
A long beep
4. Rotate the ring on the tool by hand so that a hole
can be seen below the ring.
5. Place the battery cartridge in place and pull the
switch trigger. Release it so that the adjusting ring
rotates and the hole becomes visible as illustrated.
And then remove the battery cartridge.
► 1 . Adjusting grip
6. Use an optional adjusting grip to adjust the fasten-
ing torque. Insert the pin of the adjusting grip into
the hole on the tool. And then, turn the adjusting
grip clockwise to set a greater fastening torque,
and counterclockwise to set a smaller fastening
2
torque.
7. Align the edge of the adjusting ring with your
desired number on the fastening torque scale.
3
8. Insert the battery cartridge and be sure that a fas-
tening torque has been set up by using a fastening
torque tester.
9. Rotate the ring on the tool and then tighten the
screw to secure the ring.
10. Attach the protector back to the clutch case.
NOTE:
• Numbers on the fastening torque scale is a
guideline to set up your desired fastening
torque.
9 ENGLISH
Action to be taken
Beeper
Ask your local Makita
Service Center for repair.
– Reset the alarm with the
application software.
– Restart the application
software and re-connect
the USB cable.
–
1
–
–