Maintenance; Checking The Reel-Driveshaft Grease Point - Toro Groundmaster 1018 Operator's Manual

Maintenance

Checking the
Reel-Driveshaft Grease
Point
Service Interval: Yearly
1. Remove the hardware that secures the reel-drive
assembly to the side plate
1. Socket-head screw
2. Spacer
3. Washer
2. Remove the reel-drive assembly, flat washers,
spring washers, and spacers from the side plate
(Figure 5).
3. Check the inside of the reel driveshaft
for any remaining grease.
If you do not see a sufficient amount of grease,
add more grease to the male and female spline
shaft.
(Figure 5).
Figure 5
4. Spring washer
5. Nut
(Figure
1. Reel driveshaft
4. Use the previously removed socket-head
screws, washers, and spacers to secure the
reel-drive assembly to the side plate.
g284793
5. Install the cutting unit to the traction unit; refer to
your traction unit Operator's Manual.
6)
6
Figure 6
g276424