Product Overview; Specifications; Attachments/Accessories; Operation - Toro Groundmaster 1018 Operator's Manual

18in, 21in, and 26in; 8-blade, 11-blade, and 14-blade cutting units
Table of Contents

Advertisement

Product Overview

Specifications

Traction-unit compatibility
Cutting width
Height-of-cut
Height-of-cut range
Reel bearings
Front roller
Bedknife
Bedknife adjustment
Grass shield
Counterweight
Net weight
Clip rate

Attachments/Accessories

A selection of Toro approved attachments and accessories is available for use with the machine to enhance
and expand its capabilities. Contact your Authorized Service Dealer or authorized Toro distributor or go to
www.Toro.com for a list of all approved attachments and accessories.
To ensure optimum performance and continued safety certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement parts and accessories made by other manufacturers could be
dangerous, and such use could void the product warranty.

Operation

Refer to your traction unit Operator's Manual for detailed operation instructions. Before using the cutting unit
each day, adjust the bedknife; refer to
test swath before using the cutting unit on a green to ensure that the finished cut is correct.
These cutting units mount on the appropriately-sized Greensmaster 1018, 1021 and 1026 traction
units.
Model No. 04823 and 04824
46 cm (18 inches)
Adjust the front roller by 2 vertical screws and held by 2 screws and nuts.
1.5 mm (0.062 inch) to 8 mm
(0.312 inch)
Position the traction-unit drum
in the L
setting.
OW
There are 2 sealed stainless steel, deep-groove ball bearings.
The front roller is 6.3 cm (2.5 inches) in diameter with a variety of configurations selected by the
customer.
This machine comes standard with an EdgeMax Microcut bedknife. Optional bedknives with a
variety of configurations are available. The bedknife is fastened to a machined, cast-iron bedbar
with 11 screws (Greensmaster 1018), 13 screws (Greensmaster 1021), or 16 screws (Greensmaster
1026).
There is a dual-screw adjustment to the reel with detents corresponding to 0.018 mm (0.0007 inch)
of bedknife movement for each indexed position.
The shield enhances grass discharge from the reel in wet conditions.
A cast-iron weight mounted opposite to the drive line balances the cutting unit.
Model No. 04823 and 04824
04823: 23 kg (51 lb); 04824:
24 kg (54 lb)
Refer to your traction unit Operator's Manual.
Adjusting the Bedknife Daily (page
Model No. 04832, 04833, and
04834
53 cm (21 inches)
6 mm (0.250 inch) to 16 mm
(0.625 inch)
Position the traction-unit drum
in the H
setting.
IGH
Model No. 04832, 04833, and
04834
04832: 24 kg (52 lb); 04833: 25
kg (55 lb); 04834: 26 kg (58 lb)
7). Test the quality of cut by cutting a
5
Model No. 04842 and 04843
66 cm (26 inches)
16 mm (0.625 inch)
Position the traction-unit drum
in the H
setting and install
IGH
the High Height of Cut Kit.
Model No. 04842 and 04843
04842: 27 kg (59 lb); 04843:
29 kg (63 lb)

Advertisement

Table of Contents
loading

Table of Contents