Global 695528 Assembly Instructions

Assembly Instructions
Customer Service
US: 1-800-645-2986
Before you begin: Check components to verify all are included. Assembly requires two people and must be performed on a flat and
even surface. Do not overtighten hardware as damage can occur.
Page 1 of 2
72" Recycled Plastic Picnic Table
Assembly Instructions
Model #s: 695528, 695550, 695551
Ref. Qty. Description
Table
1 2
Supports
2 2 Arm Struts
Table Top
3 3
Slats
Step 1
Position the table supports upright and parallel to each other on a
flat surface. Lay a seat slat across the mounting surface of each support
with the angle brace (mounted under seat) facing down. Attach
using 2 1/4" long carriage bolts, lock washers and hex nuts.
Repeat for the other side.
Step 2
Attach one outside edge table top slat to the supports using
2 1/4" long carriage bolts, lock washers and hex nuts. Place middle table
strut with flat side facing up and perpendicular to the underneath side of
previously installed table top board, attach using 2 1/4" long carriage bolt,
lock washer and hex nut.
CONTENTS
Ref. Qty. Description
Middle
4 1
Table Strut
5 2 Seat Slats
Hardware
H1 1
Pack
As of 10/2019