Advertisement
5.4.
Blower operation. (fig.6)
5.4.1.
Ensure machine is disconnected from power supply. (fig.6.1)
5.4.2.
Remove hose assembly from suction port. (fig.6.2)
5.4.3.
Attach hose assembly to air outlet on rear of top assembly. (fig.6.3)
5.4.4.
Connect to power supply and power on. (fig.6.4) (fig.5.5)
5.4.5.
Aim hose assembly at area to be cleared. (fig.6.6)
5.5.
Switch and auxiliary socket use. (fig.7) (fig.8)
5.5.1.
Switch operations (fig.8) :
5.5.2.
To run vacuum select Start vacuum.
5.5.3.
To run auxiliary power supply ensure machine is disconnected from power supply. fig.6.1)
5.5.4.
Lift socket cover (fig.7.1) and insert auxiliary equipment plug (fig.7.2).
5.5.5.
Connect to power supply and set rocker switch to Auxiliary power control (fig.7.3).
5.5.6.
To switch on vacuum and auxiliary power simultaneously select Start vacuum followed
by Auxiliary power.
5.5.7.
The vacuum will switch off when power is not being drawn through by the auxiliary
device within approximately 10 seconds
6. MAINTENANCE
6.5.1.
Ensure the machine is unplugged from the power supply.
6.5.2.
Disconnect the hose from the container.
6.5.3.
Undo the clasps and remove motor head from the container.
6.5.4.
Clear out any dirt or debris from the container and hose.
6.5.5.
Check the power cable to make sure it has not received any damage.
6.5.6.
Handle the filters carefully when cleaning or installing.
6.5.7.
The filter assembly contains four washable parts:
plastic filter cover (fig.9.1.1)
filter core (fig.9.1.2)
air-in sponge (fig.9.1.3)
HEPA assembly (fig.9.1.4)
6.5.8.
Wash the elements with cold or luke warm water without use of detergent. (fig.9.2, fig.9.3, fig.9.4, fig.9.5).
6.5.9.
Allow elements to air dry (fig.9.6). DO NOT use heating equipment.
6.5.10.
Check all elements for damage and replace if necessary.
© Jack Sealey Limited
Start vacuum "
", Turn off "
Original Language Version
fig.6
", Auxiliary power control "
fig.7
PC300BL Issue 2 (2,3) 7/3/19
"
fig.8
Advertisement
