Advertisement
Assembly. (fig.2)
4.2.
4.2.1.
Ensure the mains plug is disconnected. (fig.2.1).
4.2.2.
Undo clasps. (fig.2.2) .
4.2.3.
Lift off the top section assembly and filter assembly. Remove contents from inside the container. (fig.2.3) (fig.2.4) (fig.2.5).
4.2.4.
Check filter components are complete in the order as shown. (fig.2.6).
4.2.5.
Replace the filter assembly and top section assembly onto the container. (fig.2.7).
4.2.6.
Align up the top section with the clasps and snap into place by applying pressure at the mid point of the clasps. (fig.2.8)
4.2.7.
Attach hose rack to the corresponding position on head assembly. (fig.2.9).
4.2.8.
Insert handle into corresponding position on top cover. (fig.10).
4.2.9.
Insert the large end of the hose into the front inlet of the container and lock in place by turning clockwise a quarter turn. (fig.2.11).
4.2.10.
Choose the desired extension tubes and nozzle and connect onto the hose. (fig.2.12) (fig.2.13).
5. OPERATION
WARNING! Ensure you read, understand and apply Section 1 'Safety Instructions'. Reminder: DO NOT vacuum hazardous substances.
‰
Use of an incorrect cartridge filter will invalidate your warranty.
5.1.
Dry Vacuuming. (fig.3)
5.1.1.
Ensure the machine is unplugged from the power supply. (fig.3.1)
5.1.2.
Loosen clips (fig.3.2) and remove the top section and filter assembly. (fig.3.3) (fig.3.4)
5.1.3.
Check that filter components are present and assembled correctly. (fig.3.5).
5.1.4.
Place assembled unit into the body (fig.3.6) and clip in place using side clips (fig.3.7).
5.1.5.
Connect hose to body and rotate clockwise for a quarter of a turn to lock in place.(fig.3.8).
5.1.6.
Assemble required tube and hose arrangement. (fig.3.9) (fig.3.10).
5.1.7.
Plug into power supply (fig.3.11). Turn on and commence cleaning. (fig.3.12) (fig.3.13).
5.1.8.
When you have completed vacuuming, press the switch to 'Off'
© Jack Sealey Limited
fig.3
Original Language Version
PC300BL Issue 2 (2,3) 7/3/19
Advertisement
