Page 2
Setup and control ..................................6 This user’s manual is a main operating document intended for technical, maintenance, and operating staff. The manual contains information about purpose, technical details, operating principle, design, and installation of the S22 unit and all its modifications.
Page 3
www.blaubergventilatoren.de • When the unit generates unusual sounds, • Do not use damaged equipment or cables odour or emits smoke disconnect it from when connecting the unit to power mains. power supply and contact the Seller. • Do not touch the unit controls with wet •...
Page 4
www.blaubergventilatoren.de TECHNICAL DATA 42.5 mm 82 mm 13.5 mm 60 mm Power supply voltage [V] Maximum load current [A] 0.025 R 2 mm Cable type 4x0.25 mm Temperature range [˚C] +10...+45 Humidity range [%] 10 - 80 (no condensation) Ingress protection rate IP40 Mounting box for surface wall mounting...
Page 5
www.blaubergventilatoren.de 2. Connect the control panel in compliance with 3. Unfasten gently the latches on the lower part of the glass control panel using a the wiring diagram. screwdriver. Take off the control panel. Then disconnect the sensor board from the connector on the casing.
Page 6
www.blaubergventilatoren.de 6. Fasten the sensor board to the casing, and then the glass panel by pressing it until it clicks into place. SETUP AND CONTROL ADDRESSING AND PARAMETERS OF RS-485 NETWORK The control panel is compatible with the following RS-485 network parameters: •...
Page 7
www.blaubergventilatoren.de INDICATION AND FUNCTIONS OF THE CONTROL PANEL BUTTONS Speed 3 Filter maintenance Speed 2 Bypass mode Speed 1 Alarm indicator turn the unit on change speed stage, press any inactive speed button. Once activated, the button starts glowing, and the ventilation unit runs with the set speed.
Need help?
Do you have a question about the S22 and is the answer not in the manual?
Questions and answers