Cisco uBR10012 Manual page 24

Removing and Replacing an AC PEM
Figure 14
AL AR MS
When you turn on the power switch on each AC PEM, its Fault LED should go off and the Power LED
Step 13
should come on (green).
Slide the front bezel cover onto the four corner posts of the chassis and then push down, so that the posts
Step 14
are seated in the grooves above the cover holes. The AC power cables should be routed through the notch
on the right side of the cover.
AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router
24
Setting AC Power Switch to the ON Position
AL AR MS
AC
SW ITC H
AC INP UT
200 -24 0V
13A 50/
60H z
AC INP UT
200 -24 0V
13A 50/
60H z
AC
SW ITC H
A C IN P U
T
2 0 0 - 2 4 0
V
1 3 A 5 0 /6
0 H z
A C
S W IT C H
OL-24536-01