Cisco uBR10012 Manual page 17

Ac power entry module for the universal broadband router

Hide thumbs Also See for uBR10012:

Figure 7

CIS CO

100 00

AL AR MS

Plug the AC-input power cable into the power receptacle on the front panel of the AC PEM.

Step 8

Route the power cable up the front of the AC PEM and clip it into the two plastic retaining clips attached

Step 9

to the surface of the PEM. Route the power cable out through the right side, so that it will fit through the

notch on the right side of the front bezel cover.

OL-24536-01

Installing the AC PEM

P O W E R

CIS CO

F A U L T

100 00

P O W E R

F A U L T

AL AR MS

AC Power Entry Module for the Cisco uBR10012 Universal Broadband Router

Removing and Replacing an AC PEM

(Figure

Table of Contents