Charge The Controller; Charge The Receiver Collar; How To Match - AGPtek DC2R Manual

◎ Getting charge

1. Charge the controller

Connect the charger connector to the charging jack. After plugging the charger into a standard
outlet， the red LED light inside the transmitter will be lighted. Charge the controller at least 6 hours for the
first charge. After fully charged, the red LED light will be turned off automatically.

2. Charge the receiver collar

After plugging the charger into a standard outlet, the red LED light inside the receiver collar will be lighted.
Charge the receiver collar at least 6 hours for the first charge. After fully charged, the red LED light will be
turned off automatically.

◎ How to match

1. Please press the MODE button of controller for 5-10s, then the controller will be turned on. Press the
CHANNEL button and select CHANNEL1 (the small icon can be seen at the upper right of the
LED screen).
2. Press the reset button with a needle for 5s within 20 seconds (the Controller is in the ready state after it
has been started)).While finishing installing the battery, you will hear a sound "beep".